FAQ
Default solution folder, feel free to edit or delete it.
Tools needed
- Phillips screw driver
- A micro-SD card (4 Go are enough) – Warning: all content will be lost
I...
Mon, 16 Feb, 2015 at 5:55 PM
Tools needed
- Phillips screw driver
- A micro-SD card (4 Go are usually enough) – Warning: all content will be lost
...
Tue, 30 Dec, 2014 at 12:14 PM
To follow this procedure, make shure your nozzles are clean and not hot
Tools needed :
- Philips screwdriver
- 7mm (or 9/32") ...
Mon, 8 Dec, 2014 at 11:04 AM
This procedure is intended to explain how to set zim for remote support.
This should only be done when requested by zim support team.
This is don...
Fri, 12 Dec, 2014 at 5:38 PM
The
goal of this procedure is to test the 8 endstops of your zim : 2 for X Axis, 2
for Y Axis, 2 for Z Axis and 2 in the cartridges holder to sense is th...
Tue, 3 Mar, 2015 at 11:52 AM
Tool needed :
- Philips screwdriver
- 7mm (or 9/32") pipe wrench
- 2mm (or 5/64") Allen key
How to remo...
Wed, 29 Oct, 2014 at 9:40 AM
In some case, mainly faulty filament retractions, some filament stays in the nozzle and clogs it.
The following procedure describes how to unclog ...
Mon, 15 Dec, 2014 at 10:05 AM
NOTE : teflon is extremely slippery, we recommend using rubber gloves (used for dish washing for example) to handle them easily.
Warning
In or...
Tue, 3 Mar, 2015 at 1:34 PM
NOTE :
- Please follow the steps below. If the filament
is not stuck, please start from step number 11. - Please ensure that the printer is A: S...
Tue, 25 Nov, 2014 at 8:18 AM
In some cases, the filament has gone up the teflon tube and can't be removed by the usual unloading procedure.
This is usually due to filament being ...
Mon, 16 Feb, 2015 at 5:55 PM